Darmowy Kalkulator Rozstawu Tralek — Ilość & Odstęp (2026)

Jak Korzystać z Tego Kalkulatora

1. 1Measure the total railing length in inches from post to post (or end to end).
2. 2Enter the baluster width (1.5 inches for standard square balusters, 0.75 inches for round).
3. 3Enter the post width (3.5 inches for standard 4x4 posts).
4. 4Enter the number of posts and click Calculate for exact baluster count and even spacing.

O Tym Materiale

Balusters (also called spindles) are the vertical fill members in a railing system that prevent falls and meet building code. The IRC requires that a 4-inch sphere cannot pass through any opening in the railing -- this applies between balusters, between balusters and posts, between the bottom rail and the deck surface, and through any decorative opening. Standard square balusters are 1.5 inches wide (matching a 2x2 nominal), and round balusters are typically 3/4 inch in diameter. With 1.5-inch square balusters and a 4-inch maximum gap, you need approximately 3 balusters per linear foot of railing. A typical 6-foot railing section uses 17 to 19 balusters. Common materials include pressure-treated wood ($1-3 each), cedar ($2-5 each), aluminum ($3-8 each), and composite ($4-10 each). Stainless steel cable systems use 3/16-inch cables at 3-inch spacing as an alternative to vertical balusters. This calculator distributes balusters evenly within each section so that every gap is identical -- resulting in a uniform, professional appearance that automatically meets the 4-inch code requirement. Uniform spacing also simplifies installation since you can cut a single spacer block and use it for every baluster.

Wskazówki Montażowe

• •Cut a spacer block to the calculated gap width and use it between every baluster for perfectly even spacing.
• •Pre-drill screw holes in wood balusters to prevent splitting -- especially hardwoods and small cross-sections.
• •Install the bottom rail first, set all balusters with the spacer, then attach the top rail.
• •Use exterior-grade adhesive in addition to screws for long-term durability in weather-exposed railings.

Najczęstsze Błędy do Uniknięcia

• ⚠Spacing balusters too far apart -- the 4-inch sphere test applies to every opening, not just the average gap.
• ⚠Forgetting to subtract post widths from the total railing length when calculating available space.
• ⚠Not pre-drilling wood balusters -- small cross-sections split easily when screwed near the ends.
• ⚠Ignoring the gap between the deck surface and the bottom rail -- the 4-inch rule applies here too.

Powiązane Kalkulatory